General introduction
No excess film left:
- The product is packed on 4 sides by electrostatic pressing.
- The entire film surface will be used, no excess film will be created.
Energy saving:
- There is only 1 heat press bar, so it consumes less electricity than the L type machine, helping to save electricity costs.
Support for using single film rolls:
- If you need to use single film to save film costs for packaging, you just need to equip this function for the machine as required.
No excess film left:
- The product is packed on 4 sides by electrostatic pressing.
- The entire film surface will be used, no excess film will be created.
Energy saving:
- There is only 1 heat press bar, so it consumes less electricity than the L type machine, helping to save electricity costs.
Support for using single film rolls:
- If you need to use single film to save film costs for packaging, you just need to equip this function for the machine as required.
Technical parameters
| Type: | HP-20 |
| Dimensions: | L 1575mm ×W 750mm |
| Maximum film width: | 500mm (half of each film) |
| Heat press bar length: | 400mm |
| Maximum processing speed: | 30pcs/min |
| Power supply: | AC 3 phase 200/220V 50/60Hz 2KW |
| Compressed air: | 0.5Mpa |
| Edge joining form: | Heated cutting knife - electrostatic surface |
